shoe brake
ok i have cut the shape that i want out of the tyre and im in a bit of a mix there is a layer of wire in between the rubber i dint know if i cut that out and how or if i just glue it on like it is...thanks heaps every1.!!!
Views: 1
- Attachments:
-
-
P7290320.JPG, 2 MB -
P7290318.JPG, 2.3 MB
-
P7290319.JPG, 2.1 MB
-
Replies to This Discussion
-
Permalink Reply by Robbo on
-
You don't want the wire, you need to try to cut just above the wire but that's best done from the start
-
Premium MemberPermalink Reply by Toby on -
got any tips on how to cut just above the wire because i have the exact same problem
Robbo said:You don't want the wire, you need to try to cut just above the wire but that's best done from the start
-
ASRA AdminPermalink Reply by Bugs on -
The other piece of advice I'd offer is not to cut it to shape until after you've glued it to your shoe. This way you can get a very neat job.
-
Permalink Reply by tom Crane on
-
when u say de laminate the tyre, do u mean like cutting it on the sides the entire length around the tyre and then pulling the layer off the metal?
JudgeK said:You should be able to de laminate the tyre, once you have cut out the piece you want, with pliers a vice and some brute strength. The wire is normally contained in the cross ply section and comes off in diagonal strips.
-
Permalink Reply by Cooper Kruize on
-
ok if i dont want the wire how do i get rid of it
Robbo said:You don't want the wire, you need to try to cut just above the wire but that's best done from the start
© 2024 Created by Bugs.
Powered by
