Centrax on Kahas
just got my nice parcel in the post this arvo of kahas and centrax all in the one day !! woo hoo , after puttin em all together i noticed that there is like max 1mm clearance between the hanger and the inside of the wheel , does anyone think this is too close for comfort , would like to hear anyone else that has tried this yet , cheers
Views: 1
Replies are closed for this discussion.
Replies to This Discussion
-
Premium MemberPermalink Reply by Matthys on -
that may be a problem when the wheel deforms while gripping through a turn.....
just go slow and turn sharply, and if the wheel hits the hanger you know somethings wrong... -
-
Permalink Reply by Jezza on
-
throw a few more speed rings between the hanger and the bearing, and then make sure you crank the axle nut down so they can't move. Should give you a mm or two
-
-
Premium MemberPermalink Reply by leeso on -
you flip em round cause they arnt actually centre set there a tiny bit off and the lip on the inside is sharper and its better grip for the first few runs,,,same with flywheels........ that little bit might just keep you out of the hay...
not you though merrick nothing will save you..
Merrick Wildash said:Try putting the graphic of the centrax on the inside.. I know it sounds silly, But heaps of people were doing that at Maryhill cos they had the same problem. -
-
Premium MemberPermalink Reply by jay cottrell on -
cheers guys
-
© 2024 Created by Bugs.
Powered by
