Anything to stop my board from shredding ?

Replies to This Discussion

Premium MemberPermalink Reply by Jacko on December 17, 2008 at 19:31

if it aint getting chipped and scratched your not riding it....

• ▶ Reply

Premium MemberPermalink Reply by DA BEAR on December 17, 2008 at 19:39

Are you talking about droppin in or tail stalls/stops?
If its droppiin in does anyone bring in Sliptape to australia, maybe a bit of that,
or something similar would be the go.
Or if its from tail stops just fit a power pivot.
DaBear.

• ▶ Reply

Permalink Reply by Ben on December 17, 2008 at 22:56

skate.
it.
the.
end.

• ▶ Reply

Permalink Reply by dave k on December 17, 2008 at 23:27

bolt some old school slide rails on it & slide all the gutters you want

• ▶ Reply

Permalink Reply by T_Man on December 18, 2008 at 12:16

Skate it into the ground dude. If it gets worn then it's been put to good use. The only bits I try to take care of on my boards now are the nose and tail. As long as they don't chip up too much, I'm happy.

• ▶ Reply

Premium MemberPermalink Reply by blackwood on December 22, 2008 at 9:35

i cut down a tail bone and put that on the kick of my z flex. now i can manual at speed on rough road and scrap the shit out of it and my tails fine. Thrash it, its a skate board.

• ▶ Reply

▶ Reply to Discussion