ASRA - Australian Skateboard Racing Association

Well my real question is where did people get a washer for a 10/32 screw (ie. mounting hardware)? Bunnings? At this rate im drilling out a 10c piece....

Views: 707

Reply to This

Replies to This Discussion

10 or 5 c piece would work although its a commonwealth offence haha. I just use the normal deck washers that go under your bolts. Thats for bushing toestops. Could use 3 siezed up bearings or just buy a sexy looking
piece of aluminium off tim which is round like a bushing but sooo nice and all you need for that is a bolt. I used a 50mm pAnhead? Or whatever is the opposite to countersunk bolt.
I have deck washers and they are not very big - they just sink into the bushing where di you get yours?...and yes its a pan head.
Eh i have no idea where theyre from. Just found them laying around the house.. Theyre 11mm in diameter if that helps.. Bunnings would have them id say
Aight ill go see cheers
If all else fails you could just try to stuff paper or something inside the bushing so your washer stops sinking
I think the 10/5c piece will be what ill be using - cheap and avaliable in abundance
just dont show a cop

just use a deck washer on top of a bushing washer?

it worked for me

you can also use an old bearing ontop of a bushing.

Reply to Discussion

RSS

Search

© 2024   Created by Bugs.   Powered by

Badges  |  Report an Issue  |  Terms of Service