ASRA - Australian Skateboard Racing Association

Munkaes Question

Has anybody ridden 42 degree munkaes 190mm for freeride, or would like the 49 degree baseplate be better?

 

Views: 240

▶ Reply to This

Replies to This Discussion


Premium MemberPermalink Reply by Toby on May 18, 2011 at 20:35
seeing as theyre so low some people like to have some risers just to get a bit more leverage

Philip and Hugh said:
chances are he will be running this as a downhill board and not many people like risers on their trucks for DH.

Chris O'Brien said:
khiros risers? wont be as low but does the job

Jordan Fabris said:

fuck

haha anyone wanna trade 42 degree baseplates for 49's... when i get them hah

Permalink Reply by Mike River on May 18, 2011 at 22:23
Heres mine. I do everthing on this. Freeride, DH, whatever. The most I will do is a complentary wave of the skate tool near the kingpin. Got yellow venoms and orange sabre conical tops all round. Some old flat risers from the 70s (which are even drilled for Cali salom's and Lazers if you know what they are)  Even with the risers, its still lower than most drop throughs. Munkaes are righteous trucks. Versatile as hell. its all about how you set them up.
Permalink Reply by Jordannn on May 19, 2011 at 7:09
That was my bushings setup in mind.. how much do you weigh?

Mike River said:
Heres mine. I do everthing on this. Freeride, DH, whatever. The most I will do is a complentary wave of the skate tool near the kingpin. Got yellow venoms and orange sabre conical tops all round. Some old flat risers from the 70s (which are even drilled for Cali salom's and Lazers if you know what they are)  Even with the risers, its still lower than most drop throughs. Munkaes are righteous trucks. Versatile as hell. its all about how you set them up.
Permalink Reply by Mike River on May 19, 2011 at 11:08
65kg. I like em real loose mind...
Basicly, for munkaes, use softer bushings than you normally would (I normally use Purple sabres for a speedboard)
Permalink Reply by Jordannn on May 19, 2011 at 16:44

Ye, im 70.. Shouldnt be to bad.

Are yours 42 degrees?

And they also dont like like 190's so ye.. 

Permalink Reply by Mike River on May 19, 2011 at 17:34
Mine are 42.25 plates (!), 190mm hangers or whatever they are. I dunno actually, id have to get a tape measure out... Wider than a 180 for sure.
Permalink Reply by Jordannn on May 19, 2011 at 17:48

Oh sick

Sorry, the dont like like 190's haha my bad :)

Stoked, trading tonight :)

Permalink Reply by Philip and Hugh on May 19, 2011 at 23:13
most people run these on topmounts and for most people that plenty of leverage to work with

Toby said:
seeing as theyre so low some people like to have some risers just to get a bit more leverage

Philip and Hugh said:
chances are he will be running this as a downhill board and not many people like risers on their trucks for DH.

Chris O'Brien said:
khiros risers? wont be as low but does the job

Jordan Fabris said:

fuck

haha anyone wanna trade 42 degree baseplates for 49's... when i get them hah

▶ Reply to Discussion

RSS

Search

© 2025   Created by Bugs.   Powered by

Badges  |  Report an Issue  |  Terms of Service