ASRA - Australian Skateboard Racing Association

fun board

im planning to get new trucks and wheels for my sector 9 city crusher and i was going to get bennet vector 5.0 and i dont know what wheels to get?

thanks

 

Views: 271

▶ Reply to This

Replies to This Discussion

Permalink Reply by Daniel Chaseling on September 17, 2011 at 21:47

i was thinking of getting venom sidewinders : /

 or orangatang durians 86a

Permalink Reply by Daniel Chaseling on September 17, 2011 at 22:12

can someone pls respond

 


Premium MemberPermalink Reply by DA BEAR on September 17, 2011 at 22:36

I like bennett truks cos they turn a lot, but a round edge wheel with them might be too slidy.

Permalink Reply by Daniel Chaseling on September 17, 2011 at 22:43

true, what about inheats or bigzigs

 

Permalink Reply by Daniel Chaseling on September 17, 2011 at 22:48

true, what about inheats or bigzigs

DA BEAR said:

I like bennett truks cos they turn a lot, but a round edge wheel with them might be too slidy.


Premium MemberPermalink Reply by DA BEAR on September 17, 2011 at 23:01

Either will be ok, if your just cruising on it get a used  pair from the market place for 1.2price,

just read the dimensions of the city crusher.

I'd get 4.3's instead of 5.0.


Premium MemberPermalink Reply by Kelly Carter on September 17, 2011 at 23:01

Get some small sectors

Permalink Reply by Bozac on September 18, 2011 at 0:34

bennett 4.3 or 5.0 with lime zigs or 4prez would be good for that deck, be warned the trucks are a lot more divey than the gullwing trucks that it came with but awesome fun on a short board and will enable you to pump better

Permalink Reply by Cents on September 18, 2011 at 14:02

Buy a pair of 7 degree wedges as well (as well as hardware to suit). Put 1 bennett up front and the gullwing at the back and wedge both (with the wedges facing forward). Put really soft bushings up front and hard bushings in the back and presto awesome city pumper!!! 

Permalink Reply by Daniel Chaseling on September 19, 2011 at 17:54

i  got randles R-II, turns out that their very turny

sorry i couldn't resist  :)

any how, they are turny but heps high up.

Permalink Reply by Cents on September 19, 2011 at 22:43

The bennetts are quite a high conventional truck - though not as high as randals. With such a short board it'll feel a bit skechy being so high but randals are generally a more stable truck. Also you think randals are turny compared to a bennet? LoL swap out those bennett stock bushings for some reflex and you'll be carving circles. 

Permalink Reply by Daniel Chaseling on September 20, 2011 at 15:50

i can turn my garage and it less than 1.7 across. bennets must be gun at turning then

 

 

▶ Reply to Discussion

RSS

Search

© 2024   Created by Bugs.   Powered by

Badges  |  Report an Issue  |  Terms of Service