Where to buy wood In Brisbane

Replies to This Discussion

Permalink Reply by Angus Allen on September 18, 2012 at 13:43

Sam, I'm in Brissie, and sorry, I don't know where to buy wood. Maybe a boatbuilder? If you can use the bunnings wood to make the shape you want, maybe you can stiffen it up with a layer of fibreglass (glued with Epoxy) somewhere near the bottom. You would need to run the glass fibres in the direction of the board length. GOOD luck

Dex

Permalink Reply by Angus Allen on September 18, 2012 at 13:44

Good luck wasn't meant to be in capitals, I wasn't shouting ;-)

Permalink Reply by Sam ferguson on September 18, 2012 at 13:44

Thanks for your help

Premium MemberPermalink Reply by Adam on September 18, 2012 at 14:31

check the plywood supliers in the yellow pages.

mr ply n wood

sharpes

i think there is a boral ply too.

 

Permalink Reply by Sam ferguson on September 18, 2012 at 14:43

Thanks :)

Permalink Reply by Sam ferguson on October 11, 2012 at 18:18

I ended up using 3 mm bunnings ply but using 5 sheets this worked well and the board has no flex this board was a top mount downhill board this time I want to make a dropped deck will this wood still be suitable or not and the Board will have 1 inch of drop

Premium MemberPermalink Reply by Deeks63 on October 11, 2012 at 19:54

What are you going to use to press it Sam?  Using 3mm ply takes some pressure to make a drop deck!  Here's a blank I made some time ago before cutting out using 3mm hoop pine ply - vaccuum bag and a shit-load of clamps! (2" Drop)

Permalink Reply by Sam ferguson on October 11, 2012 at 20:39

i will be making a press similar to this

Permalink Reply by Sam ferguson on October 11, 2012 at 20:45

And if I were to use the vacuum bag method does it need to be a special vacuum bag or just a regular vacuum bag

Premium MemberPermalink Reply by Deeks63 on October 11, 2012 at 21:53

I have a Roarockit bag (70" x 20"). Works very nicely, but like I said, for big drops and sharp curves, it needs some help from clamps...

Permalink Reply by Sam ferguson on October 11, 2012 at 21:59

Ok I'll give it a go and see what happens thanks for your help :)

Permalink Reply by James Frederiksen on October 12, 2012 at 16:22

I've used the bunnings ply for 2 boards now, with 3 sheets it was way to flexy but 4 seemed alright, a lot comes down to length & cave. If you struggle to find supplies let me know, I may or may not have some 1/8 Baltic Birch, just sayin.

• ‹ Previous
• 1
• 2
• Next ›
• Page