Full face visor
I just bought a full face helmet that was originally for bmx. I was wondering what was the best way o make a sturdy visor for this helmet?
Views: 57
Replies to This Discussion
-
Premium MemberPermalink Reply by Dani on -
See that search bar in the to right of the page? You will find hundreds of topics of the same subject there.
-
Permalink Reply by Matt Ryan on
-
http://www.skateboardracing.org.au/forum/topics/full-face-visor-how-to
theres a link to a thread i made about it and theres more photo's on my profile... if you have any questions after that message me and ill try and help as best i can.
-
Premium MemberPermalink Reply by Adam on -
www.skateboardracing.org.au/photo/visorcre8tivesk8plug-1?context=user
i made this one after reading the link above. You might want to make a litle washer to go between the screws and the helmet to allow the visor to open,
-
-
no i dont have a template... to make a template tape to pieces of printer paper together and draw the opening of you helmet the add the bolt tabs and make it a bit bigger if you like to get it symmetrical cut out one half of the template and then draw it onto another two pieces of paper
-
-
yes acrylic should work as apparently Plexiglas (what i used) is just a brand of high grade acrylic
Dermott Pascoe said:but what if you want to make a visor out of acrylic would that work?
-
-
nahh sunny coast mate.. have you figured every thing out?... and do you know where are you are gonna get the acrylic from?
Dermott Pascoe said:that's utterly sweet -are you a brisbane skater?
Matt Ryan said:yes acrylic should work as apparently Plexiglas (what i used) is just a brand of high grade acrylic
Dermott Pascoe said:but what if you want to make a visor out of acrylic would that work?
-
-
sweet... good luck and post up picks when youve finished it .. and what thickness are you going to be using?
© 2024 Created by Bugs.
Powered by
