ASRA - Australian Skateboard Racing Association

Obviously they are not done fully but?????

The far one is mine, I can't wait to try it, symmetrical shape but not concave. For pushing ride with the right end forward so back foot has w for slides, ride other way for bombing so the front foot gets the arch support and the lock of the little pocket and the back foot can move around. it may end up the opposite in practice but that was the theory. What do ya all think. Both have 12mm drop down.

The other one is symmetrical concave, as asked for.

Tags: board, build

Views: 27

Reply to This

Replies to This Discussion

nicely done dude. you're theory will work with the w for the arch of the front foot, though, looking at the pic it might not be quite far enough forward.

will have to get out for a roll on one!
will give ya feedback when i get to roll on it ;)
It's not very far forward as that is where the front foot would be there when just pushing but swap around the other way and arch is supported, will mean that i will have to keep trucks the same tightness our adjust depending on the session but in theory it will mean the board is adaptable.
But thanks heaps.
As far as i am concerned you and pete make the best boards in the country and i only hope to make a few that might ride somewhere like them. Obviously i only have access to prelam ply but bamboo is in the pipe line (from the same place pete gets it when needed Eumundi) just have to get my renos finished first. One more bathroom to go, and the rest.

If you're in Sydney ask jacko about the bottom one ( joe is taking it down to him for Bday jam) or if coming to the sunny coast give us a yell and i will lend it to ya or something, I'd live to try a glyde one day.
I reckon Adam that you really have your concave's nailed. The other shot from side on lower down really shows it up better than these two shots though. I really like the shape of the kicks on Jacko's board as well, perfect.

Keep up the good work!
sweet. can't wait.

Jacko said:
will give ya feedback when i get to roll on it ;)
i stuffed up the attachments.
unco
this is no. two and three so ???????

Steve said:
I reckon Adam that you really have your concave's nailed. The other shot from side on lower down really shows it up better than these two shots though. I really like the shape of the kicks on Jacko's board as well, perfect.
Keep up the good work!
anyone else?
all glassed up now and ready to sand

Reply to Discussion

RSS

Search

© 2024   Created by Bugs.   Powered by

Badges  |  Report an Issue  |  Terms of Service